![]() It is another effective way to compensate for the thinner 12 gauge steel tubing. Having the thicker end plates in these structurally important connection points is another good design choice by Force USA. ![]() Fast shipping (via freight shipping) – I discuss shipping details here.īelow are photos of the max height measurements of the base MyRack unit, the Cable Crossover and the Lat Pulldown/Low Row:.The rack comes in three boxes each attachment comes in a single box.Free standing design, but the feet have built-in holes for bolting down if wanted.The region with 1″ hole spacing is much larger compared to other Westside style racks.1″ holes on left and right sides of each upright that can be used for certain other accessories (e.g.5/8″ hole size on front and back of each upright.54 laser cut holes on front and back of each upright for adjusting height of j-hooks, safeties and other attachments.Gusset plates on base of all uprights + reinforcement plates at all other joints to bolster structural integrity.12 gauge steel uprights (end plates on the upper cross bracings tubes that connect to uprights are thicker than 12 gauge).I’ve included height measurement photos at the end of this spec list. And the Cable Crossover Attachment came in at ~87.5”. The Lat Pulldown/Low Row Attachment measured in at 86.75” at its highest point. MyRack Video Tourīefore I get into anything, I’ll put this video “tour” of my complete MyRack setup, so you can get an up-close look at this power rack and all of its attachments: This will be helpful if you want a quick answer as to whether this rack is right for you. Cable Crossover OR Lat Pulldown/Low Row OR Bothīefore I get into the nitty-gritty details, I’ll present you with the table below where I summarize the major pros and cons of the MyRack and give my overall rating.Westside Hole Spacing with 54 Laser Cut Holes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |